Polar3D Hardware: P3D00000 - P3D01999

Replacing the Feed Block
The feed block is the milled aluminum piece that sits atop the extruder assembly. The filament enters the hole in the top of the feed block and is pres...
Wed, 7 Mar, 2018 at 2:36 PM
Replacing the SD Card
Have you recieved a new SD Card, or reflashed your SD Card? If so click HERE for instructions on how to replace the SD Card.
Wed, 25 Jan, 2017 at 2:45 PM
Replacing the Fan in the Back of the Printer
Click HERE for the full document. Replacing the Fan The fan on our first generation printer keeps the daughterboard from overheating. The printer will...
Wed, 7 Mar, 2018 at 2:41 PM
Camera Replacement
Click HERE to learn how to properly replace the camera on your printer.
Wed, 25 Jan, 2017 at 2:52 PM
Broken Z-Tube Replacement Guide
If your Z-Axis tube is broken click HERE to learn how to replace it.
Wed, 25 Jan, 2017 at 3:07 PM
Replacing the Daughter Board
Click HERE to learn how to replace the Daughter Board on your Polar 3D Printer. 
Mon, 13 Feb, 2017 at 11:08 AM
Reflashing The SD Card or Manually Updating Your Printer's Software
Note: Only for Printers with serial number between P3D00100 and P3D01999. Doing so without the advice/counsel of our support team or on any machines outside...
Wed, 7 Mar, 2018 at 2:39 PM
Connection Woes
Polar 3D Connection Woes This article only applies to printers with serial numbers at and before P3D01999 Unplug ethernet and  USB if either are ...
Mon, 12 Mar, 2018 at 5:24 PM