Applying Hairspray to the Build Plate
Modified on: Wed, 14 Mar, 2018 at 11:44 PM
If your part comes off the plate you may see it stick to the nozzle and create a blob. Even worse - the part may not stick to the plate at any point and you'll see only a blob.
Assuming your Z-Offset is correct and your nozzle comes all the way down to the plate, you're probably just a little short on hairspray. Hold back 6-8 inches and spray back and forth.
Give it 10 minutes or so, or until its dry to the touch. You can apply multiple coats if needed.
Did you find it helpful?
Sorry we couldn't be helpful. Help us improve this article with your feedback.