Start a new topic

Print location changes

After the last firmware upgrade, the location of prints change to a different place from where I located them. I've had multiple copies overlap and most prints get placed in the center of the buildplate. I try to place them along the outer edge where the will be less spinning of the plate and printing more efficiently.


Any help with this?


1 person has this problem
1 Comment

Thank you so much for this. I was into this issue and tired to tinker around to check if its possible but couldnt get it done. Now that i have  https://plex.software seen the way you did it, thanks guys

with

regards

https://kodi.software/ https://luckypatcher.pro/ 

Login or Signup to post a comment